Operation Check

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF SYSTEM: OPERATION CHECK

1. CHECK AUTO OPERATION

NOTICE:
Make sure that initialization is completed before inspection Programming and Relearning.

HINT
When pressing the switch for 0.3 seconds or less, the roof glass moves but auto operation does not operate.

(a) Turn the power switch on (IG).

(b) When the roof glass is fully closed, press the SLIDE OPEN switch for 0.3 seconds or more. Check that the roof glass automatically slides until it reaches the comfort stop position.

(c) When the roof glass is in the comfort stop position, press the SLIDE OPEN switch again for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully opened.

(d) When the roof glass is fully open, press the SLIDE CLOSE switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully tilted upward.

(e) Close the sliding roof glass to the fully closed position by the manual tilt down operation.

(f) When the roof glass is fully closed, press the TILT UP switch for 0.3 seconds or more. Check that the roof glass automatically tilts up until it is fully tilted upward.

(g) When the auto function is operating, check that pressing any of the sliding roof switches stops the roof glass operation.

2. CHECK SLIDING ROOF OPERATION AFTER POWER SWITCH IS TURNED OFF

NOTICE:
Make sure that initialization is completed before inspection Programming and Relearning.

(a) Turn the power switch from on (IG) to off, and check that the sliding roof can be operated. Then open the driver or front passenger side door once, and check that the sliding roof cannot be operated.

(b) Turn the power switch from on (IG) to off and wait for approximately 43 seconds. Check that the sliding roof cannot be operated.

(c) Operate the auto function with the driver or front passenger side door open. While the roof glass is moving, turn the power switch off. Check that the roof glass stops immediately.

3. CHECK JAM PROTECTION FUNCTION

CAUTION:
* Do not use a part of your body, for example, your hand, to check the jam protection function.
* Do not allow anything to become caught in the sliding roof by accident while performing this inspection.
* Perform the inspection from the inside of the vehicle.
NOTICE:
* Do not use hard objects, such as a hammer, to avoid damaging the roof.
* Make sure that initialization is completed before inspection Programming and Relearning.
* If the jam protection function does not operate, reset the sliding roof drive gear (motor).
* The jam protection function does not operate when the roof glass is close to the fully closed position.

(a) When the slide close function is operating and an object is caught between the vehicle body and glass, check that the roof glass opens a distance of 218 mm (8.58 in.) from the point of contact with the object, or opens fully if an opening distance of 218 mm (8.58 in.) is not available.

(b) When the tilt down function is operating, and an object is caught between the vehicle body and the roof glass, check that the sliding roof tilts up fully.

4. CHECK SLIDING ROOF OPEN WARNING

(a) Open the sliding roof by using the sliding roof switch.

(b) When the power switch is turned from on (IG) to off and the driver door is opened with the key in the vehicle, check that the warning buzzer in the combination meter assembly sounds once. Then, check that the multi-information display on the combination meter assembly displays "MOON ROOF OPENED".