Reassembly

BRAKE (FRONT): FRONT BRAKE: REASSEMBLY

1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG

HINT
Fully tighten the front disc brake bleeder plug after bleeding the system.

2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

3. INSTALL PISTON SEAL

(a) Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.





Text in Illustration





(b) Install the piston seal to the disc brake cylinder assembly.

NOTICE:
Securely install the piston seal to the groove of the disc brake cylinder.

4. INSTALL FRONT DISC BRAKE PISTON

(a) Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.





Text in Illustration





(b) Install the cylinder boot to the front disc brake piston.

(c) Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston, and install it to the disc brake cylinder assembly.

NOTICE:
Do not install the piston forcibly in the disc brake cylinder.

5. INSTALL CYLINDER BOOT

(a) Install the cylinder boot to the disc brake cylinder assembly.





Text in Illustration





NOTICE:
Securely install the cylinder boot to the groove of the disc brake cylinder and front disc brake piston.

(b) Using a screwdriver with its tip wrapped with vinyl tape, install a new set ring.





Text in Illustration





NOTICE:
* Securely install the set ring to the outer groove of the cylinder boot.
* Do not damage the cylinder boot.