Headlight Leveling ECU Power Source Circuit

LIGHTING (EXT): LIGHTING SYSTEM: Headlight Leveling ECU Power Source Circuit
- Headlight Leveling ECU Power Source Circuit

DESCRIPTION

This circuit detects the state of the power switch, and sends it to the headlight leveling ECU assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Inspect the fuse for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / HL Auto Leveling / Data List.

(e) Read the display on the Techstream.

HL Auto Leveling





OK:

Normal condition listed above is displayed.

NG -- CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - HEADLIGHT LEVELING ECU ASSEMBLY)

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Exterior Lighting System

2. CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - HEADLIGHT LEVELING ECU ASSEMBLY)

(a) Disconnect the A46 headlight leveling ECU assembly connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE HEADLIGHT LEVELING ECU ASSEMBLY Removal