Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL

NOTICE:
While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the battery is connected.

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace the front axle hub and bearing assembly.

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal, Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Removal

3. REMOVE FRONT WHEEL

4. REMOVE FRONT FENDER LINER

HINT
Use the same procedure for the LH side and RH side Removal.

5. REMOVE FRONT SPEED SENSOR

(a) Remove the 2 clamps and disconnect the front speed sensor connector.

(b) Remove the bolt and No. 2 sensor clamp from the body.

Text in Illustration

(d) Remove the clamp from the shock absorber assembly.

(e) Remove the bolt and front speed sensor.

NOTICE:
* Prevent foreign matter from attaching to the front speed sensor tip.
* Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.