Wireless Door Lock Control System

DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM: B1242: Wireless Door Lock Tuner Circuit Malfunction
B1242 - Wireless Door Lock Tuner Circuit Malfunction

DESCRIPTION

* The door control receiver is used to receive electric waves relating to the entry functions of the smart access system with push-button start. The certification ECU decodes the requested smart access system with push-button start operation by identifying a key code based on electric waves received via the door control receiver and the door control receiver.

* The door control receiver receives a signal from the wireless door control transmitter and sends signals to the main body ECU through the certification ECU.

* The certification ECU then sends a command, according to the requested operation, to each ECU. (e.g. If door lock operation is requested, the ECU sends a door lock command to the main body ECU.)





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER)

(a) Disconnect the E13 certification ECU connector and M5 door control receiver connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. INSPECT CERTIFICATION ECU

(a) Reconnect the E13 ECU connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





NG -- REPLACE CERTIFICATION ECU
OK -- Continue to next step.

3. REPLACE DOOR CONTROL RECEIVER

(a) Replace the door control receiver with a normal one.

(b) Perform the registration procedure Engine Immobilizer System.

OK:

The system returns to normal operation.

NG -- REPLACE CERTIFICATION ECU

OK -- END