Dynamic Radar Cruise Control System
CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P0503: Vehicle Speed Sensor "A" Intermittent / Erratic / High
P0503 - Vehicle Speed Sensor "A" Intermittent / Erratic / High
DESCRIPTION
If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while the cruise control is operating, the ECM determines that there is a momentary interruption or noise, and outputs a DTC.
WIRING DIAGRAM
INSPECTION PROCEDURE
This DTC may be output by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.
PROCEDURE
1. READ OUTPUT DTC (VEHICLE STABILITY CONTROL SYSTEM)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
(e) Read the DTCs Reading and Clearing Diagnostic Trouble Codes.
Result:
B -- GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART) Vehicle Stability Control System
A -- Continue to next step.
2. REPLACE COMBINATION METER ASSEMBLY
(a) Replace the combination meter assembly Removal.
NEXT -- Continue to next step.
3. CHECK WHETHER DTC OUTPUT RECURS (DTC P0503)
(a) Clear the DTCs Dynamic Radar Cruise Control System.
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed for which cruise control operation is possible.
(2) Turn the cruise control main switch on.
(3) Push the -SET switch to activate the cruise control.
(c) Read the DTCs Dynamic Radar Cruise Control System.
OK:
DTC is not output.
NG -- REPLACE ECM Removal
OK -- END