Dynamic Radar Cruise Control System
CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P0575: Cruise Control Input Circuit
P0575 - Cruise Control Input Circuit
DESCRIPTION
This DTC indicates a malfunction in the ECM.
HINT
The ECM receives signals from each sensor to control all the functions of the cruise control with the microcomputer. When a malfunction is detected, fail-safe remains on until the engine switch is turned off.
INSPECTION PROCEDURE
PROCEDURE
1. READ DTC OUTPUT (P0575)
(a) Clear the DTCs Dynamic Radar Cruise Control System.
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed for which cruise control operation is possible.
(2) Turn the cruise control main switch (ON-OFF button) on.
(3) Push the -SET switch to activate the cruise control.
(c) Check the DTCs Dynamic Radar Cruise Control System.
OK:
DTC is not output.
NG -- REPLACE ECM Removal
OK -- USE SIMULATION METHOD TO CHECK Electronic Circuit Inspection Procedure