Installation

SEAT: REAR SEAT ASSEMBLY: INSTALLATION

1. INSTALL REAR SEATBACK ASSEMBLY

(a) Place the rear seatback assembly in the cabin.





NOTICE:
Be careful not to damage the vehicle body.

(b) Install the rear seatback assembly with the 4 bolts.

Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

(c) Install the rear seat shoulder belt guide RH with the 3 screws.





(d) Pass the seat belt through and close the caps of the rear seat shoulder belt guide RH.

HINT
Use the same procedure for the LH side and RH side.

(e) Install the rear seat center shoulder belt guide with the 2 screws.





(f) Pass the seat belt through and close the cap of the rear seat center shoulder belt guide.

2. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY

3. INSTALL REAR SEAT HEADREST ASSEMBLY

4. INSTALL REAR SEAT CUSHION ASSEMBLY

(a) Attach the 2 rear hooks of the seat cushion to the seatback.





(b) Attach the 2 front hooks of the seat cushion to the vehicle body.

(c) Confirm that the seat cushion is firmly installed.

NOTICE:
When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.

HINT
After installing the seat cushion, vertically (up and down) rock the area around the rear seat cushion lock hooks. Make sure that there is no abnormal noise. If abnormal noise is heard, replace the rear seat cushion lock hooks with new ones.