Disassembly

LIGHTING: HEADLIGHT ASSEMBLY: DISASSEMBLY

1. REMOVE FRONT BUMPER SIDE SUPPORT

(a) Remove the 3 screws and front bumper side support.





2. REMOVE NO. 2 HEADLIGHT BULB

(a) Remove the No. 2 headlight bulb as shown in the illustration.





NOTICE:
Do not touch the bulb glass.

3. REMOVE NO. 1 HEADLIGHT BULB (for Halogen Headlight)

(a) Remove the No. 1 headlight bulb as shown in the illustration.





NOTICE:
Do not touch the bulb glass.

4. REMOVE HEADLIGHT SOCKET COVER (for HID Headlight)

(a) Remove the headlight socket cover as shown in the illustration.





5. REMOVE DISCHARGE HEADLIGHT BULB (for HID Headlight)

(a) Separate the light control ECU socket as shown in the illustration.





(b) Release the set spring and remove the discharge headlight bulb as shown in the illustration.





NOTICE:
Do not touch the bulb glass.

6. REMOVE FRONT SIDE MARKER LIGHT BULB

(a) Turn the front side marker light bulb and front side marker light socket in the direction indicated by the arrow and remove them as a unit.





(b) Remove the front side marker light bulb from the front side marker light socket.

7. REMOVE FRONT TURN SIGNAL LIGHT BULB

(a) Turn the front turn signal light bulb and front turn signal light socket in the direction indicated by the arrow and remove them as a unit.





(b) Remove the front turn signal light bulb from the front turn signal light socket.

8. REMOVE HEADLIGHT LEVELING MOTOR (for HID Headlight)

(a) Align the notches of the headlight leveling motor and the housing, and pull out the headlight leveling motor slightly.





(b) Lower the tip of the headlight leveling motor to disengage it from the reflector and remove the headlight leveling motor.





9. REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING (for HID Headlight)

(a) Remove the headlight leveling motor base packing.

NOTICE:
After the headlight leveling motor base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

10. REMOVE LIGHT CONTROL ECU SUB-ASSEMBLY (for HID Headlight)

(a) Remove the 4 screws.





(b) Disconnect the connector and remove the light control ECU sub-assembly.

11. REMOVE HEADLIGHT GASKET (for HID Headlight)

(a) Remove the headlight gasket.

NOTICE:
After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

12. REMOVE HEADLIGHT SWIVEL MOTOR (for HID Headlight)

(a) Disconnect the connector.





(b) Remove the 3 screws and headlight swivel motor.