Alignment: Specifications

Front Wheel Alignment








Measuring points:

A
Ground clearance of front wheel center

B
Ground clearance of lower suspension arm No. 2 bushing set bolt head center

C
Ground clearance of rear wheel center

D
Ground clearance of strut rod set bolt center

NOTICE:
* Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
* Be sure to perform measurement on a level surface.
* If it is necessary to go under the vehicle for measurement, confirm that the parking brake is applied and the vehicle is secured with chocks.





HINT
If toe-in is not within the specified range, adjust it at the rack ends.

















NOTICE:
* Perform the inspection while the vehicle is unloaded.
* The maximum tolerance of the right and left difference for the camber and caster is 45' (0.75°) or less.

Rear Wheel Alignment













HINT
* Try to adjust toe-in to the center of the specified range.
* One turn of each adjusting tube will adjust toe-in by approximately 10.8 mm (0.425 in.).





HINT
Camber is not adjustable. If the measurement is not within the specification range, inspect the suspension parts for damage and/or wear, and replace them if necessary.

PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

HINT
Perform yaw rate sensor zero point calibration Programming and Relearning.

CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION

HINT
Check steering angle sensor zero point calibration C1290.