Cylinder Head Assembly

Cylinder head RH bolts
1st 36 Nm (367 kgf-cm, 27 ft-lbf)
2nd 90°
Final another 90°





Cylinder head LH bolts
1st 36 Nm (367 kgf-cm, 27 ft-lbf)
2nd 90°
Final another 90°





Tighten the 2 bolts in the order shown
Torque 30 Nm (306 kgf-cm, 22 ft-lbf)





Bolt re-usability





Standard outside diameter 10.85 to 11.00 mm (0.4272 to 0.4331 in.)
Minimum outside diameter 10.70 mm (0.4213 in.)
Measuring Point 103 mm (4.06 in.)

If the diameter is less than the minimum, replace the cylinder head bolt

Standard warpage





Maximum warpage





If the warpage is greater than the maximum, replace the cylinder head assembly.

1. Install Camshaft Bearing Cap (for RH Side)
Temporarily tighten the 8 bolts in the order shown in the illustration
Torque 10 Nm (102 kgf-cm, 7 ft-lbf)





2. Install Camshaft housing sub-assembly RH
Torque 28 Nm (286 kgf-cm, 21 ft-lbf)

RH:

3. Tighten the 8 bolts in the order shown in the illustration (in step 1.)
Torque 16 Nm (163 kgf-cm, 12 ft-lbf)






1. Install Camshaft Bearing Cap (for LH Side)
Temporarily tighten the 8 bolts in the order shown in the illustration
Torque 10 Nm (102 kgf-cm, 7 ft-lbf)





2. Install Camshaft housing sub-assembly LH
1st 28 Nm (286 kgf-cm, 21 ft-lbf)

LH:

3. Tighten the 8 bolts in the order shown in the illustration (in step 1.)
Torque 16 Nm (163 kgf-cm, 12 ft-lbf)






Intake Manifold Torque & Sequence Specifications
Exhaust Manifold Torque & Sequence Specifications
Camshaft Gear/Sprocket Torque Specifications