Repair Instruction - Customize Parameters
INTRODUCTION: REPAIR INSTRUCTION: CUSTOMIZE PARAMETERS
1. POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Tilt&Telescopic
2. AIR CONDITIONING SYSTEM
Air Conditioner
3. THEFT DETERRENT SYSTEM
Security
* *: for North America
4. LIGHTING SYSTEM
Illuminated Entry
Light Control
5. POWER DOOR LOCK CONTROL SYSTEM
Door Lock
* *1: for Brazil
* *2: for Korean and Brazil
Wireless D Lock
6. WIRELESS DOOR LOCK CONTROL SYSTEM
Main Body ECU
7. SMART ACCESS SYSTEM WITH PUSH-BUTTON START (DOOR LOCK)
Smart
Wireless Door Lock
Warning
8. ENTRY UNLOCK MODE SWITCHING FUNCTION
(a) Check that the power source mode is OFF and the LED on the electrical key is not blinking. Press the LOCK switch and one of the other switches on the electrical key at the same time for approximately 5 seconds while the electrical key is in the action area.
* When the switches are pressed and held for 5 seconds, the entry door unlock mode changes in the following order: driver door mode, all door mode.
NOTICE:
After pressing and holding the switches for 5 seconds, wait 5 seconds before performing the same procedure again.
* Driver door unlock mode:
When the driver door's touch sensor is touched, only the driver door unlocks. When another touch sensor is touched, all doors unlock.
* All door unlock mode:
When the touch sensor is touched, all doors unlock.
(b) The certification ECU receives this signal from the entry door control receiver and changes the smart access system with push-button start to the entry unlock mode.
(c) The certification ECU sounds the buzzers of the wireless door lock buzzer and combination meter to inform the user that the mode has been switched.
HINT
The function only changes the entry unlock mode of the smart access system with push-button start. It does not switch the unlocking of the wireless door lock control.
9. ELECTRICAL KEY CANCEL
The electrical key cancel operation disables the following functions:
* Entry Unlock/Lock
* Entry Luggage Compartment Open
* Electrical Key Lock-in Prevention
* Warning
* Memory Call
(a) The operation procedures are as follows:
Precondition:
Engine switch off, driver side door closed and unlocked.
(1) Unlock the driver side door once with the UNLOCK switch of the electrical key.
(2) Open the driver door within 5 seconds.
(3) Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds.
(4) Close and open the driver door twice within 30 seconds.
(Driver door: Close -> Open -> Close -> Open)
(5) Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds.
(6) Close and open the driver door within 30 seconds.
(Driver door: Close -> Open)
(7) Close the driver door within 5 seconds.
When electrical key cancel is activated, the wireless door lock buzzer sounds twice.
To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.
10. METER/GAUGE SYSTEM
Warning
Display
HINT
*: This setting is only valid for the buzzer which sounds at the 20 km/h (12 mph) or more.
11. INTUITIVE PARK ASSIST SYSTEM
Warning
Sensor
Display
12. POWER MIRROR CONTROL SYSTEM
Mirror
13. REAR SUNSHADE SYSTEM
Others
14. SLIDING ROOF SYSTEM
Sliding roof ECU
* *1: Except models with DVD Navigation System
* *2: This function is linked with the power window wireless transmitter-linked function. If the power window wireless transmitter-linked function is set to OFF, the sliding roof wireless transmitter-linked function will not operate even when it is set to ON.
* *3: This function is linked with the power window key-linked function. If the power window key-linked function is set to OFF, the sliding roof key-linked function will not operate even when it is set to ON.