Shift Interlock: Testing and Inspection

U660E AUTOMATIC TRANSAXLE: SHIFT LOCK SYSTEM: ON-VEHICLE INSPECTION

1. CHECK SHIFT LOCK OPERATION

(a) Move the shift lever to P.

(b) Turn the engine switch off.

(c) Check that the shift lever cannot be moved to any position other than P.

(d) Turn the engine switch on (IG), depress the brake pedal and check that the shift lever can be moved to another position.

If operation cannot be done as specified, inspect the shift lock control unit.

2. CHECK SHIFT LOCK RELEASE BUTTON OPERATION

(a) Using a screwdriver, remove the shift lock release cover.

(b) When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P.

If operation cannot be done as specified, check the shift lever assembly installation condition.

3. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY

(a) Measure the voltage according to the value(s) in the table below.





HINT
Do not disconnect the shift lock control unit assembly connector.

Standard voltage:





(b) Measure the resistance according to the value(s) in the table below.





HINT
Do not disconnect the shift lock control unit assembly connector.

If the result is not as specified, replace the shift lever assembly.

Standard resistance: