Operation CHARM: Car repair manuals for everyone.

P060E





2AZ-FXE ENGINE CONTROL: SFI SYSTEM: P060E: Internal Control Module Throttle Position Performance
P060E - Internal Control Module Throttle Position Performance

MONITOR DESCRIPTION

The hybrid vehicle control ECU monitors the input signals of the No. 1 throttle position sensor. When the hybrid vehicle control ECU monitors the input signal of the No. 1 throttle position sensor, if the input signal and control signal deviate, the DTC is stored.





MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS

Case 1





Case 2





TYPICAL MALFUNCTION THRESHOLDS

Case 1





Case 2





CONFIRMATION DRIVING PATTERN

1. Connect the Techstream to the DLC3.

2. Turn the power switch on (IG) and turn the Techstream on.

3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC operation) Reading and Clearing Diagnostic Trouble Codes.

4. Turn the Techstream off.

5. Turn the power switch off.

6. Disconnect the Techstream.

7. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.

8. Connect the cable to the negative (-) auxiliary battery terminal.

9. Connect the Techstream to the DLC3.

10. Turn the power switch on (IG) and turn the Techstream on.

11. Wait 16 seconds or more.

12. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

13. Read the pending DTCs.

HINT
- If a pending DTC is output, the system is malfunctioning.
- If a pending DTC is not output, perform the following procedure.

14. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.

15. Input the DTC: P060E.

16. Check the DTC judgment result.





HINT
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.

17. If the judgment result is INCOMPLETE or N/A and no pending DTC is output, perform a universal trip and check for permanent DTCs Reading and Clearing Diagnostic Trouble Codes.

HINT
- If a permanent DTC is output, the system is malfunctioning.
- If no permanent DTC is output, the system is normal.

INSPECTION PROCEDURE

HINT
Read freeze frame data using the Techstream. The hybrid vehicle control ECU records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

PROCEDURE

1. READ OUTPUT DTC (DTC P060E)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(e) Turn the power switch off and turn the Techstream off.

(f) Disconnect the Techstream.

(g) Disconnect the cable from the auxiliary battery negative (-) terminal and wait for 1 minute.

(h) Connect the cable to the auxiliary battery negative (-) terminal.

(i) Connect the Techstream to the DLC3.

(j) Turn the power switch on (IG).

(k) Wait 16 seconds or more.

(l) Turn the Techstream on.

(m) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(n) Read the DTCs.

Result:





B -- REPLACE HYBRID VEHICLE CONTROL ECU Removal

A -- CHECK FOR INTERMITTENT PROBLEMS Check for Intermittent Problems