Front Door: Adjustments

DOOR / HATCH: FRONT DOOR: ADJUSTMENT





Text in Illustration





CAUTION:
Before adjusting the door positions of vehicles equipped with side and curtain shield airbags, be sure to disconnect the battery. After adjustment, check that the SRS warning light is operating normally and there are no SRS DTCs output.

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
* Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts installed on it. Substitute the centering bolts with standard bolts when making adjustments.
* Specified torque for standard bolts is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSPECT FRONT DOOR

(a) Check that the clearance measurements of areas *a through *n are within each standard range.





Standard Clearance





2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT Removal

3. PRECAUTION (w/ Navigation System)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

5. ADJUST FRONT DOOR

(a) Using SST, loosen the hinge bolts on the vehicle body and adjust the door position.

SST : 09812-00010





(b) Tighten the hinge bolts on the vehicle body after the adjustment.

Torque : 26 Nm (265 kgf-cm, 19 ft-lbf)

(c) Loosen the hinge bolts on the door and adjust the door position.

(d) Tighten the hinge bolts on the door after the adjustment.

Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

(e) Using a screwdriver, disengage the 4 claws and remove door lock striker cover.





Text in Illustration





HINT
Tape the screwdriver tip before use.

(f) Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.





(g) Using a brass bar and a hammer, hit the striker to adjust its position.

(h) Using a T40 "TORX" socket wrench, tighten the striker mounting screws after the adjustment.

Torque : 23 Nm (235 kgf-cm, 17 ft-lbf)

(i) Engage the 4 claws and install the door lock striker cover.





6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation

7. INSPECT SRS WARNING LIGHT

Diagnosis System

8. INSTALL LUGGAGE COMPARTMENT FLOOR MAT Installation