Removal

DOOR LOCK: REAR DOOR LOCK: REMOVAL

1. PRECAUTION

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT Removal

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

5. REMOVE REAR DOOR ARMREST COVER Disassembly

6. REMOVE NO. 1 REAR DOOR STIFFENER CUSHION Disassembly

7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP Disassembly

9. REMOVE REAR DOOR ARMREST SET BRACKET Disassembly

10. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

11. REMOVE REAR DOOR GLASS RUN Disassembly

12. REMOVE NO. 2 REAR DOOR VENT SEAL Disassembly

13. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Disassembly

14. REMOVE REAR DOOR QUARTER WINDOW GLASS WITH WEATHERSTRIP Disassembly

15. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

16. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

17. REMOVE REAR DOOR LOCK ASSEMBLY

(a) Disengage the rear door lock remote control cable assembly and rear door inside locking cable assembly.





(b) Using a T30 "TORX" socket wrench, remove the 3 screws.

(c) Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

(d) Remove the door lock wiring harness seal from the rear door lock assembly.





18. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY Disassembly

19. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY Disassembly