Power Mirror Control System (w/ Memory)
MIRROR (EXT): POWER MIRROR CONTROL SYSTEM (w/ Memory): TERMINALS OF ECU
1. CHECK OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER SIDE)
(a) Disconnect the I8 connector.
(b) Measure the voltage according to the value(s) in the table below.
HINT
Measure the values on the wire harness side with the connector disconnected.
Standard Voltage
If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Measure the resistance according to the value(s) in the table below.
HINT
Measure the values on the wire harness side with the connector disconnected.
Standard Resistance
If the result is not as specified, there may be a malfunction on the wire harness side.
(d) Reconnect the I8 connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage
2. CHECK OUTER MIRROR CONTROL ECU ASSEMBLY (PASSENGER SIDE)
(a) Disconnect the H8 connector.
(b) Measure the voltage according to the value(s) in the table below.
HINT
Measure the values on the wire harness side with the connector disconnected.
Standard Voltage
If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Measure the resistance according to the value(s) in the table below.
HINT
Measure the values on the wire harness side with the connector disconnected.
Standard Resistance
If the result is not as specified, there may be a malfunction on the wire harness side.
(d) Reconnect the H8 connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage