Installation

2AZ-FXE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

(a) Install a new gasket onto the engine coolant temperature sensor.

(b) Using SST, install the engine coolant temperature sensor.





Text in Illustration





SST : 09023-12900

without SST - Torque : 20 Nm (200 kgf-cm, 14 ft-lbf)

with SST - Torque : 17 Nm (171 kgf-cm, 12 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).
* This torque value is effective when SST is parallel to the torque wrench Service Precautions.

(c) Connect the engine coolant temperature sensor connector.

2. INSTALL ENGINE WIRE

(a) Install the connector clamp from the bracket.

(b) Connect the 4 connectors.

(c) Install the 2 bolts and disconnect the 2 ground cables.

3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

5. ADD COOLANT (for Engine) Coolant (for Engine)

6. INSPECT FOR COOLANT LEAK (for Engine)

7. INSTALL NO. 1 ENGINE UNDER COVER

8. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY Installation

9. INSTALL COWL BODY MOUNTING REINFORCEMENT RH Installation

10. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL Installation

11. INSTALL WATER GUARD PLATE RH Installation

12. INSTALL FRONT WIPER MOTOR AND LINK

(a) Install the front wiper motor and link Installation.

13. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation