Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Using SST and a torque wrench, install the center airbag sensor assembly with the 3 bolts.





Text in Illustration





SST : 09961-00950

without SST - Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)

with SST - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when SST is parallel to a torque wrench.
* If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* When the power switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

(d) Connect the connectors to the center airbag sensor assembly as shown in the illustration.

NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(e) Check that the waterproof sheet is properly set.

(f) Check that there is no looseness in the installation parts of the center airbag sensor assembly.

2. INSTALL REAR NO. 2 AIR DUCT

(a) Engage the 6 claws to install the rear No. 2 air duct.

3. INSTALL NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY Installation

4. INSTALL NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY Installation

5. INSTALL COOLER BLOWER ASSEMBLY Installation

6. INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET Installation

7. INSTALL NO. 4 CONSOLE BOX DUCT Installation

8. INSTALL NO. 2 CONSOLE BOX MOUNTING BRACKET Installation

9. INSTALL CONSOLE BOX Installation

10. INSTALL CONSOLE BOX LH Installation

11. INSTALL CONSOLE BOX RH Installation

12. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY Installation

13. INSTALL CONSOLE BOX CARPET Installation

14. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY Installation

15. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (w/o Seat Heater System) Installation

16. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (w/ Seat Heater System) Installation

17. INSTALL FRONT CONSOLE BOX COVER Installation

18. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

19. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY (w/o Navigation System) Installation

20. INSTALL REMOTE TOUCH ASSEMBLY (w/ Navigation System) Installation

21. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

22. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

23. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

Installation

24. INSTALL FRONT SEAT ASSEMBLY

Installation