Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION

1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

(a) Install the spiral cable with sensor sub-assembly Installation.

NOTICE:
* Do not replace the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).
* Do not rotate the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).
* Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
* Do not remove the steering angle sensor from the spiral cable with sensor sub-assembly.

2. INSTALL UPPER STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic Steering Column) Installation

3. INSTALL UPPER STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column) Installation

4. INSTALL LOWER STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic Steering Column) Installation

5. INSTALL LOWER STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column) Installation

6. INSTALL LOWER NO. 2 STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column) Installation

7. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

8. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Installation

9. INSTALL STEERING WHEEL ASSEMBLY

HINT
Refer to the procedure from Install Steering Wheel Assembly Installation.