Installation

A960E AUTOMATIC TRANSMISSION: EXTENSION HOUSING REAR OIL SEAL: INSTALLATION

1. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL

(a) Coat the lip of a new oil seal with MP grease.





(b) Using SST and a hammer, drive in a new oil seal.

SST : 09325-40010

Oil seal drive in depth:

5.4 to 5.8 mm (0.213 to 0.228 in.)

NOTICE:
* Keep the lip free from foreign matter.
* Do not tap the oil seal at an angle.

2. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Installation

3. INSTALL OUTSIDE AIR GUIDE PLATE RH Installation

4. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation

5. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

6. INSTALL OXYGEN SENSOR Installation

7. INSTALL FRONT CENTER FLOOR BRACE Installation

8. INSTALL NO. 1 REAR FLOOR PANEL BRACE Installation

9. INSTALL NO. 2 FLOOR UNDER COVER Installation

10. INSTALL NO. 1 FLOOR UNDER COVER Installation

11. ADD AUTOMATIC TRANSMISSION FLUID

Procedures

12. INSTALL NO. 2 ENGINE UNDER COVER

13. CHECK FOR EXHAUST GAS LEAKS Installation