Removal

AUDIO / VIDEO: RADIO RECEIVER: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

Service Precautions

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
* A hard disk drive (HDD) is built into the multi-display to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the multi-display.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD)

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) Removal

4. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

5. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) Removal

7. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

8. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

9. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) Removal

10. REMOVE INSTRUMENT PANEL COIN BOX (w/o Ashtray) Removal

11. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Removal

12. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

13. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

14. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Multi-display)

(a) Remove the 4 bolts.





(b) Pull the integration control panel with radio receiver assembly toward the rear of the vehicle.

(c) Disconnect each connector and remove the panel.

15. REMOVE NO. 1 RADIO BRACKET (w/o Multi-display)

(a) Remove the 6 bolts and No. 1 radio bracket.





16. REMOVE NO. 2 RADIO BRACKET (w/o Multi-display)

(a) Remove the 6 bolts and No. 2 radio bracket.





17. REMOVE RADIO RECEIVER ASSEMBLY (w/o Multi-display)

(a) Slide the integration control panel in the direction shown by the arrow to remove the radio receiver assembly.





18. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Multi-display)

(a) Remove the 4 bolts.





(b) Pull the display and navigation module display with radio receiver assembly toward the rear of the vehicle.

(c) Disconnect each connector and remove the display and navigation module display with radio receiver assembly.

19. REMOVE NO. 1 RADIO BRACKET (w/ Multi-display)

(a) Disengage the connector clamp.





(b) Remove the 7 bolts and No. 1 radio bracket.





20. REMOVE NO. 2 RADIO BRACKET (w/ Multi-display)

(a) Remove the 7 bolts and No. 2 radio bracket.





21. REMOVE RADIO RECEIVER ASSEMBLY (w/ Multi-display)

(a) Slide the display and navigation module display assembly in the direction shown by the arrow to remove the radio receiver assembly.