Installation

CRUISE CONTROL: CLUTCH SWITCH: INSTALLATION

1. INSTALL CLUTCH SWITCH ASSEMBLY

(a) Fully loosen the lock nut of the clutch switch assembly.

(b) Adjust the clutch switch until the threaded portion makes gentle contact with the cushion. Tighten the lock nut and verify the contact of the switch threaded portion with the cushion.





Torque : 16 Nm (160 kgf-cm, 12 ft-lbf)

(c) Connect the connector.

2. INSTALL MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

(a) Install the main body ECU (cowl side junction block LH) with the 2 nuts and bolt.





Nut - Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

Bolt - Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)

(b) Connect all connectors.

3. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY Installation

4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

6. INSTALL INSTRUMENT SIDE PANEL LH Installation

7. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation

8. INSTALL DOOR SCUFF PLATE ASSEMBLY LH Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. INSPECT SRS WARNING LIGHT

Diagnosis System