Installation

4GR-FSE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL REAR ENGINE OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

NOTICE:
Keep the lip free of foreign matter.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.





SST : 09223-15030

SST : 09950-70010

09951-07150

Oil seal tap in depth:

0 to 1.0 mm (0 to 0.0394 in.)

NOTICE:
* Wipe extra grease off the crankshaft.
* Keep the lip free of foreign matter.
* Do not tap on the oil seal at an angle.

2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

(a) Using SST, hold the crankshaft pulley.





SST : 09213-70011

09213-70020

SST : 09330-00021

(b) Using several steps, install and tighten 8 new bolts uniformly in the sequence shown in the illustration.





Torque : 73 Nm (741 kgf-cm, 54 ft-lbf)

NOTICE:
* Do not reuse the flywheel installation bolts. Be sure to check the tightening torque within 5 minutes after tightening.
* Do not impact or damage the flywheel installation bolts. Be sure to handle them carefully.
* Make sure that the seating surface of the flywheel installation bolts and installation surfaces of the crankshaft and flywheel are free of oil and foreign matter.

3. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

(a) Using SST, hold the crankshaft pulley.





SST : 09213-70011

09213-70020

SST : 09330-00021

(b) Clean the 8 bolts and 8 bolt holes.

(c) Install the front drive plate spacer.





HINT
Align the pin of the front drive spacer with the pin hole of the crankshaft.

(d) Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.





Text in Illustration





(e) Apply adhesive to 2 or 3 threads of the 8 bolts.





Text in Illustration





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(f) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.





Torque : 83 Nm (846 kgf-cm, 61 ft-lbf)

NOTICE:
Do not start the engine for at least 1 hour after installation.

4. INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

HINT
Installation.

5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

(a) Install the automatic transmission assembly for A960E Installation.

6. INSPECT FOR OIL LEAK