Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR

(a) Connect the connector.





(b) Install the yaw rate and acceleration sensor with the 2 bolts.





Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

NOTICE:
* Do not damage the yaw rate and acceleration sensor.
* Make sure that the yaw rate and acceleration sensor is installed securely.

(c) Install the 2 wire harness clamps.

2. INSTALL NO. 2 CONSOLE BOX DUCT (for Automatic Transmission) Installation

3. INSTALL NO. 2 CONSOLE BOX DUCT (for Manual Transmission) Installation

4. INSTALL CONSOLE BOX

HINT
Refer to the instructions for installation of the console box Installation.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

HINT
Programming and Relearning.

7. INSPECT SENSOR SIGNAL

HINT
Test Mode Procedure.