Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
* If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE REAR WHEEL

4. REMOVE REAR SPEED SENSOR WIRE

(a) Using a screwdriver, disconnect the rear speed sensor wire.





5. REMOVE REAR SPEED SENSOR

(a) Remove the bolt and rear speed sensor.





NOTICE:
Prevent foreign matter from attaching to the sensor tip.