Installation

CLUTCH: CLUTCH UNIT: INSTALLATION

1. INSTALL RELEASE FORK SUPPORT

(a) Install the release fork support spring to the release fork support.





Text in Illustration





(b) Install the release fork support to the manual transmission unit assembly with the 2 bolts.

Torque : 26 Nm (265 kgf-cm, 19 ft-lbf)

2. INSTALL CLUTCH RELEASE HUB BALL BEARING

(a) Install the thrust cone spring, thrust cone spring plate washer and clutch release hub ball bearing to the clutch release hub as shown in the illustration.





Text in Illustration





(b) Using a snap ring expander, install the snap ring.

3. INSTALL CLUTCH RELEASE BEARING HUB

(a) Fill the groove inside the release bearing hub with grease.





Text in Illustration





(b) Apply MP grease to the contact surface between the release hub bearing and the clutch cover.





Text in Illustration





NOTICE:
* Be sure to apply an even and thin layer of grease.
* Excessive grease or a lump of grease on the contact surface between the release hub bearing and the clutch cover can splatter and result in trouble.

(c) Using SST, secure the clutch release hub ball bearing.

SST : 09950-60020

09726-05021

09951-00810





(d) Install the clutch cover assembly, release bearing plate washer and release bearing wave washer.

(e) Using a snap ring expander, install the snap ring.





4. INSTALL CLUTCH COVER ASSEMBLY

(a) Apply clutch spline grease to the input shaft spline.

Sealant:

Toyota Genuine Clutch Spline Grease or equivalent

(b) Install the clutch cover assembly to the input shaft.

5. INSTALL CLUTCH DISC ASSEMBLY

(a) Install the clutch disc assembly to the transmission unit.





Text in Illustration





NOTICE:
Take care not to insert the clutch disc assembly in the wrong direction.

6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

(a) Install the pin and wave washer to the clutch release fork with a new E-ring.





Text in Illustration





(b) Apply grease to the contact surface between the release fork and release bearing hub, the contact surface between the release fork and push rod, and release fork pivot points as shown in the illustration.





Text in Illustration





(c) Install the clutch release fork sub-assembly to the release fork support.

NOTICE:
* Do not use excess force to install the clutch release fork sub-assembly.
* After installation, move the fork back and forth to check that the clutch release bearing hub slides smoothly.

7. INSTALL MANUAL TRANSMISSION ASSEMBLY

Install the manual transmission assembly Installation.