Cylinder Head Assembly

Cylinder Head RH

Step 1
Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps and in the sequence shown in the illustration.

Right:

Torque 36 Nm (367 kgf-cm, 27 ft-lbf)

Step 2
Tighten the cylinder head bolts another 90°.

Step 3
Tighten the cylinder head bolts by an additional 90°.


Cylinder Head LH

Step 1

Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps in the sequence shown in the illustration.

Left:

Torque 36 Nm (367 kgf-cm, 27 ft-lbf)

Step 2
Tighten the cylinder head bolts by 90°.

Step 3
Tighten the cylinder head bolts by an additional 90°.

Tighten the 2 bolts in the order shown in the illustration.





Torque 30 Nm (306 kgf-cm, 22 ft-lbf)

Minimum outside diameter 10.70 mm (0.4213 in.)
If the diameter is less than the minimum, replace the cylinder head bolt.

Standard warpage:





Maximum warpage:





Camshaft Bearing Cap (for Bank 1)

Temporarily tighten the 9 bolts in the order shown in the illustration.





Torque 10 Nm (102 kgf-cm, 7 ft-lbf)

Camshaft Housing RH

Install the camshaft housing RH and tighten the 14 bolts in the order shown in the illustration.





Torque 28 Nm (286 kgf-cm, 21 ft-lbf)

Tighten the 9 bolts in the order shown in the illustration.





Torque 16 Nm (163 kgf-cm, 12 ft-lbf)

Camshaft Bearing Cap (for Bank 2)

Temporarily tighten the 8 bolts in the order shown in the illustration.





Torque 10 Nm (102 kgf-cm, 7 ft-lbf)

Camshaft Housing LH

Install the camshaft housing LH and tighten the 13 bolts in the order shown in the illustration.





Torque 28 Nm (286 kgf-cm, 21 ft-lbf)

Tighten the 8 bolts in the order shown in the illustration.





Torque 16 Nm (163 kgf-cm, 12 ft-lbf)

Intake Manifold Specifications

Exhaust Manifold Specifications

Camshaft Gear/Sprocket Specifications