Disassembly

BRAKE (REAR): REAR BRAKE: DISASSEMBLY

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.

1. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSHING

(a) Remove the rear disc brake cylinder slide bushing from the rear disc brake cylinder assembly.





2. REMOVE REAR DISC BRAKE BUSHING DUST BOOT

(a) Remove the rear disc brake bushing dust boot from the caliper support bracket.





3. REMOVE REAR DISC BRAKE PISTON

(a) Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder assembly.





(b) Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder assembly.

CAUTION:
Do not place your fingers in front of the rear disc brake piston when using compressed air.

NOTICE:
Do not spatter the brake fluid.

4. REMOVE CYLINDER BOOT

(a) Remove the cylinder boot from the rear disc brake piston or rear disc brake cylinder assembly.

5. REMOVE PISTON SEAL

(a) Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the rear disc brake cylinder assembly.





Text in Illustration





NOTICE:
Be careful not to damage the rear disc brake cylinder assembly.

6. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

7. REMOVE REAR DISC BRAKE BLEEDER PLUG