Removal

2GR-FSE ENGINE CONTROL: ECM: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE ECM COVER

(a) Remove the 3 bolts and ECM cover.





NOTICE:
* Remove all water on and around the ECM cover.
* Perform the inspection indoors to avoid rain.
* Be sure to prevent water intrusion to the ECM (connectors and screw parts).

6. REMOVE ECM

(a) Disconnect the ECM connectors.

(1) Using a screwdriver, disconnect the connector holder.





(2) Disconnect the 6 ECM connectors.

(b) Remove the 2 nuts and ECM.