Removal
2GR-FSE ENGINE CONTROL: AIR FUEL RATIO SENSOR: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3. REMOVE COOL AIR INTAKE DUCT SEAL Removal
4. REMOVE ENGINE ROOM SIDE COVER Removal
5. REMOVE ENGINE ROOM SIDE COVER LH Removal
6. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
7. REMOVE ENGINE UNDER COVER
8. REMOVE FRONT FLOOR COVER LH Removal
9. REMOVE FRONT FLOOR COVER RH Removal
10. REMOVE NO. 2 FLOOR UNDER COVER Removal
11. REMOVE NO. 1 FLOOR UNDER COVER Removal
12. REMOVE NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY LH Removal
13. REMOVE NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY RH Removal
14. REMOVE NO. 2 ENGINE UNDER COVER
15. REMOVE REAR BODY SUPPORT BRACKET Removal
16. REMOVE FRONT CENTER FLOOR BRACE Removal
17. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal
18. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE Removal
19. REMOVE POWER STEERING ECU ASSEMBLY
(a) Remove the power steering ECU assembly Removal.
20. REMOVE BATTERY TRAY
(a) Remove the 3 bolts and battery tray.
21. SEPARATE NO. 4 ENGINE WIRE
(a) Remove the engine room No. 1 relay block cover.
(b) Remove the nut and separate the wire from the engine room No. 1 junction block.
(c) Disconnect the connector and remove the 2 clamps.
22. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
(a) Disconnect the air fuel ratio sensor connector.
(b) Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.
SST : 09224-00010
23. REMOVE NO. 3 ENGINE ROOM RELAY BLOCK ASSEMBLY Removal
24. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal
25. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
(a) Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.
SST : 09224-00010