Installation

2GR-FSE FUEL: FUEL PUMP: INSTALLATION

1. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE

(a) Install a new gasket to the fuel suction tube.

(b) Connect the fuel tube with the clip.





(c) Set the fuel suction tube assembly with pump and gauge to the fuel tank.

NOTICE:
* Make sure that the fuel sender gauge arm does not bend.
* Do not damage the fuel tube.

(d) Align the protrusion of the fuel suction tube and the cutout of the fuel tank vent tube set plate.





Text in Illustration





(e) While holding the fuel suction tube by hand, install the fuel tank vent tube to the fuel tank with the 8 bolts.

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

(f) Connect the fuel tube.

(1) Push the fuel tube joint in the plug of the fuel suction plate, then install the 2 tube joint clips.





Text in Illustration





NOTICE:
* Check that there are no scratches or foreign objects on the connecting parts.
* Check that the fuel tube joint is inserted securely.
* Check that the tube joint clips are on the collars of the fuel tube joints.
* After installing the tube joint clips, check that the fuel tube joints have not been pulled off.
* Be careful not to damage any clips. If a clip is damaged, replace it.

(g) Connect the fuel suction tube connector.





2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

3. INSPECT FOR FUEL LEAK Fuel System

4. INSTALL NO. 2 REAR FLOOR SERVICE HOLE COVER

(a) Install the No. 2 rear floor service hole cover with new butyl tape.





5. INSTALL REAR SEAT CUSHION ASSEMBLY LH Installation