Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: INSTALLATION

1. INSTALL SEAT POSITION SENSOR

(a) Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.





(b) Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position sensor.





Text in Illustration





NOTICE:
* If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
* When installing the seat position sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

HINT
Be sure that the clearance between the seat position sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(c) Using a T30 "TORX" socket wrench, tighten the "TORX" screw to install the seat position sensor.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Make sure that the clearance between the seat position sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(e) Connect the connector.

(f) Check that there is no looseness in the installation parts of the seat position sensor.

2. INSTALL FRONT SEAT ASSEMBLY LH

HINT
Refer to the procedure from Install Front Seat Assembly Installation.

3. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check Reading and Clearing Diagnostic Trouble Codes.