Removal

2GR-FSE STARTING: ENGINE SWITCH: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

5. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

6. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal

7. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Removal

8. REMOVE INSTRUMENT PANEL COIN BOX (w/o Ashtray) Removal

9. REMOVE REAR ASH RECEPTACLE ASSEMBLY (w/ Ashtray) Removal

10. REMOVE CONSOLE BOX REGISTER ASSEMBLY (w/ Ashtray) Removal

11. REMOVE CONSOLE BOX REGISTER ASSEMBLY (w/o Ashtray) Removal

12. REMOVE CONSOLE BOX Removal

13. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

14. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

15. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Multi-display) Removal

16. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Multi-display) Removal

17. REMOVE ENGINE SWITCH

(a) Disconnect the switch connector.





(b) Detach the 2 claws and remove the switch.