Installation

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL STEERING KNUCKLE

(a) Temporarily install the steering knuckle to the upper suspension arm with the nut.





(b) Install the steering knuckle to the lower ball joint with the 2 bolts.





Torque : 120 Nm (1224 kgf-cm, 89 ft-lbf)

(c) Fully tighten the nut and install a new clip.





Torque : 87 Nm (887 kgf-cm, 64 ft-lbf)

NOTICE:
If the holes for the clip are not aligned, further tighten the nut up to 60°.

2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY Installation

3. INSTALL FRONT DISC

for Floating Type Caliper Installation

for Opposed Type Caliper Installation

4. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Replacement

5. CONNECT FRONT SPEED SENSOR WIRE Installation

6. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Front Wheel Alignment.

8. CHECK FOR SPEED SENSOR SIGNAL

Test Mode Procedure.