Body - Initializing Power Windows
L-SB-0118-11September 20, 2011
Initialization of Power Window During PDS
Service Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
Introduction
As a result of the removal of the DCC fuse, the "one-touch open and close" and "jam protection" functions of each door's power window will be inoperative due to loss of the power window position memory stored in the microcomputer.
Initialize each door's power window after installing the DCC fuse into its original location during Pre-Delivery Service (PDS).
Any time the battery terminal has been disconnected, each door's power window MUST be initialized.
Warranty Information
Initialization Procedure
1. Cycle the ignition switch to the "IG-ON" position.
2. Close the driver and passenger doors and verify the quarter windows and retractable hardtop are fully closed.
3. Push "DOWN" the driver's door power window switch and lower the window halfway.
4. Pull "UP" the driver's door power window switch until the window closes, and hold it until the switch stops blinking and remains illuminated.
5. Check for proper operation of the "one-touch open and close" function by fully pushing the switch "DOWN" once and fully pulling the switch "UP" once.
NOTE
Open the door and confirm that the window automatically retracts (lowers) slightly. Confirm that the window automatically returns to the fully closed position when the door is closed. If not, initialization is not complete. Please repeat steps 1 - 5.
6. Repeat steps 1 - 5 for passenger door power window.