B2288
THEFT DETERRENT / KEYLESS ENTRY: SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Start Function): B2288: Steering Lock Signal Circuit Malfunction
B2288 - Steering Lock Signal Circuit Malfunction
DESCRIPTION
This DTC is output when the power source control ECU cannot detect the unlock condition of the steering lock within a specified time.
HINT
When the power source control ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. PERFORM INITIALIZATION
(a) Perform initialization Steering Lock System.
NEXT -- Continue to next step.
2. CHECK FOR DTC
(a) Clear the DTC Smart Access System With Push-Button Start (for Start Function).
(b) Check if the trouble occurs again 18 to 22 seconds after the engine switch is turned on (IG).
Result:
B -- GO TO OTHER FLOWCHART (DTC B2285) B2285
C -- END (INITIALIZATION WAS NOT COMPLETED)
A -- Continue to next step.
3. CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Check for Steering Lock System DTC.
OK:
DTC is not output.
NG -- GO TO DIAGNOSTIC TROUBLE CODE CHART (STEERING LOCK SYSTEM) Steering Lock System
OK -- Continue to next step.
4. CHECK STEERING LOCK
(a) Check if the steering lock is released when turning the engine switch on (ACC).
OK:
The steering lock is released.
NG -- GO TO STEERING LOCK SYSTEM (STEERING LOCK CAN NOT BE UNLOCKED) Steering Lock System
OK -- Continue to next step.
5. READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Check the Data List for proper functioning of the steering lock function.
HINT
When using the Techstream with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the Techstream and vehicle starts.
Power Source Control
OK:
"ON" (Steering is unlocked) and "OFF" (Steering is locked appear on the screen.
NG -- REPLACE STEERING LOCK ECU Disassembly
OK -- REPLACE POWER SOURCE CONTROL ECU