B279A
THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM: B279A: Theft Deterrent System Communication Line High Fixation
B279A - Theft Deterrent System Communication Line High Fixation
DESCRIPTION
If the communication line (EFIO-IMI) to the ID code box (immobiliser code ECU) is stuck on HI output, the ECM outputs this DTC.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID Engine Immobilizer System.
* If the ECM is replaced, register the ECU communication ID Engine Immobilizer System.
PROCEDURE
1. CHECK DTC OUTPUT
(a) Clear the DTCs Engine Immobilizer System.
(b) Recheck for DTCs.
HINT
If any DTCs other than DTC B279A are output, troubleshoot those DTCs first.
Result:
A -- GO TO DIAGNOSTIC TROUBLE CODE CHART Engine Immobilizer System
B -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (ID CODE BOX (IMMOBILISER CODE ECU) - ECM)
(a) Disconnect the ID code box (immobiliser code ECU) connector.
(b) Disconnect the ECM connector.
(c) Measure the resistance and voltage according to the value(s) in the table below.
Standard Resistance:
Standard Voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK ECM (INPUT)
(a) Reconnect the ID code box (immobiliser code ECU) connector.
(b) Reconnect the ECM connector.
(c) Measure the waveform.
Waveform (Reference):
OK:
Waveform is output normally (see illustration).
NG -- REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
OK -- REPLACE ECM Removal
4. REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
(a) Replace the ID code box (immobiliser code ECU) Removal.
NEXT -- Continue to next step.
5. REGISTER ECU CODE
(a) Register the ECU code Engine Immobilizer System.
NEXT -- Continue to next step.
6. REGISTER ECU COMMUNICATION ID
(a) Register the ECU communication ID Engine Immobilizer System.
NEXT -- Continue to next step.
7. CHECK DTC OUTPUT
(a) Clear the DTCs Engine Immobilizer System.
(b) Recheck for DTCs.
OK:
B279A output does not recur.
NG -- REPLACE ECM Removal
OK -- END (ID CODE BOX (IMMOBILISER CODE ECU) IS DEFECTIVE)