Removal

AUDIO / VIDEO: RADIO RECEIVER: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
* A hard disk drive (HDD) is built into the display and navigation module display (HDD navigation system) to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the display and navigation module display (HDD navigation system).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD)

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

5. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

6. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal

7. REMOVE INSTRUMENT PANEL BOX ASSEMBLY (w/o Ashtray) Removal

8. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Removal

9. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

10. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

11. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Multi-display)

(a) Remove the 4 bolts.





(b) Pull the integration control panel with radio receiver assembly toward the rear of the vehicle.

(c) Disconnect each connector and remove the panel.

12. REMOVE NO. 1 RADIO BRACKET (w/o Multi-display)

(a) Remove the 6 bolts and No. 1 radio bracket.





13. REMOVE NO. 2 RADIO BRACKET (w/o Multi-display)

(a) Remove the 6 bolts and No. 2 radio bracket.





14. REMOVE RADIO RECEIVER ASSEMBLY (w/o Multi-display)

(a) Slide the integration control panel in the direction shown by the arrow to remove the radio receiver assembly.





15. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Multi-display)

(a) Remove the 4 bolts.





(b) Pull the display and navigation module display with radio receiver assembly toward the rear of the vehicle.

(c) Disconnect each connector and remove the display and navigation module display with radio receiver assembly.

16. REMOVE NO. 1 RADIO BRACKET (w/ Multi-display)

(a) Disengage the connector clamp.





(b) Remove the 7 bolts and No. 1 radio bracket.





17. REMOVE NO. 2 RADIO BRACKET (w/ Multi-display)

(a) Remove the 7 bolts and No. 2 radio bracket.





18. REMOVE RADIO RECEIVER ASSEMBLY (w/ Multi-display)

(a) Slide the display and navigation module display assembly in the direction shown by the arrow to remove the radio receiver assembly.