Removal

DOOR LOCK: REAR DOOR LOCK: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

5. REMOVE REAR DOOR TRIM COVER Disassembly

6. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

7. REMOVE REAR DOOR GLASS RUN Disassembly

8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Disassembly

9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

10. REMOVE REAR DOOR LOCK ASSEMBLY

(a) Disconnect the connector.

(b) Using a "TORX" socket wrench (T30), remove the 3 screws and the rear door lock assembly.





(c) Slide the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

(d) Remove the door lock wiring harness seal from the rear door lock assembly.

11. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

(a) Using a screwdriver, disengage the claw.





(b) Remove the rear door lock remote control cable assembly.





12. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

(a) Using a screwdriver, disengage the 3 claws.





(b) Remove the rear door inside locking cable assembly.