Installation

MIRROR: OUTER REAR VIEW MIRROR: INSTALLATION

HINT
* Use the same procedures for the LH side and RH side.
* The procedures listed below are for the LH side.
* A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY





(a) Install the mirror with the 3 nuts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Attach the 3 clamps.

(c) Connect the connector.

2. INSTALL FRONT NO. 2 DOOR SERVICE HOLE COVER Reassembly

3. INSTALL DOOR FRAME GARNISH Reassembly

4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG Reassembly

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.