Master Warning Light Malfunction

STEERING COLUMN: VARIABLE GEAR RATIO STEERING SYSTEM: Master Warning Light Malfunction
- Master Warning Light Malfunction

DESCRIPTION

If the steering control ECU detects that VGRS system has a malfunction, warning information is transmitted to the combination meter via CAN.

The combination meter will turn the master warning light on based on this information.

Warning information is transmitted via the following route:

* Steering control ECU -> (CAN) -> Skid control ECU -> (CAN) -> Combination meter

Connecting terminals TC and CG of the DLC3 makes the master warning light blink and outputs DTCs.

WIRING DIAGRAM





INSPECTION PROCEDURE

HINT
Check that there is no problem in CAN communication before performing the following procedure.

If there are any problems in these communications, first troubleshoot them and then proceed to the troubleshooting below.

PROCEDURE

1. CHECK BATTERY

(a) Measure the battery voltage.

Standard voltage:





NG -- REPLACE BATTERY
OK -- Continue to next step.

2. PERFORM ACTIVE TEST USING TECHSTREAM (COMBINATION METER)

(a) Select the Active Test, use Techstream to generate a control command, and then check that the master warning light turns on/off.

Combination meter:





OK:

Indicator light turns on / turns off.

NG -- REPLACE COMBINATION METER Removal
OK -- Continue to next step.

3. CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)

(a) Check for DTCs in the electronically controlled brake system Reading and Clearing Diagnostic Trouble Codes.

Result:





NG -- GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM Electronically Controlled Brake System

OK -- REPLACE STEERING CONTROL ECU Removal