Canada - Instruments - Calibration of Compass
BulletinL-TCI-3006
Issue Date
September 13, 2011
Title:
INITIAL CALIBRATION OF COMPASS DURING PDS
Service Category
General
Section
Pre-Delivery Service
Market
Canada
APPLICABILITY:
INTRODUCTION:
Some 2012 model LS460 vehicles are equipped with a compass in the rear view mirror. Use the following procedure to perform initial calibration of the compass during Pre-Delivery Service (PDS).
WARRANTY INFORMATION:
CALIBRATION PROCEDURE:
1. Cycle the ignition switch to the "IG-ON" position and hold the "AUTO" switch for 6 seconds until the zone number appears on the compass display.
HINT
Pushing the "AUTO" switch for 3 seconds turns ON or OFF the compass display.
2. Push the "AUTO" switch to select the number of the zone where the vehicle is located.
See the map in figure 3 for zone reference.
3. Start the engine and push the "AUTO" switch for about 9 seconds until "C" appears on the display.
4. Drive the vehicle slowly at 8 km/h (5 mph), or less, in a circle until the direction is displayed. If there is NOT enough space to drive in a circle, drive around the block until the direction is displayed.
Once the direction is displayed, the calibration is complete.
NOTE
- Do NOT perform calibration of the compass in a place where the Earth's magnetic field is subject to interference by artificial magnetic fields (underground parking, under a steel tower, between buildings, roof parking, near a railroad crossing, near a large vehicle, etc.)
- During calibration, do NOT operate electric systems (moon roof, power windows, etc.) as they may interfere with the calibration.