Pinout Values and Diagnostic Parameters

ENGINE HOOD / DOOR: DOOR CLOSER SYSTEM: TERMINALS OF ECU

1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)





(a) Disconnect the DA, DD, L11, L12 and L13 ECU connectors.

(b) Measure the resistance and voltage according to the value(s) in the table below.





* If the result is not as specified, there may be a malfunction on the wire harness side.

2. CHECK FRONT DOOR ECU LH





(a) Disconnect the N10 ECU connector.

(b) Measure the resistance and voltage according to the value(s) in the table below.





* If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the N10 ECU connector.

(d) Measure the voltage according to the value(s) in the table below.





* If the result is not as specified, the ECU may have a malfunction.

3. CHECK FRONT DOOR ECU RH





(a) Disconnect the N1 ECU connector.

(b) Measure the resistance and voltage according to the value(s) in the table below.





* If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the N1 ECU connector.

(d) Measure the voltage according to the value(s) in the table below.





* If the result is not as specified, the ECU may be malfunctioning.

4. CHECK REAR DOOR ECU LH





(a) Disconnect the O14 ECU connector.

(b) Measure the resistance and voltage according to the value(s) in the table below.





* If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the O14 ECU connector.

(d) Measure the voltage according to the value(s) in the table below.





* If the result is not as specified, the ECU may have a malfunction.

5. CHECK REAR DOOR ECU RH





(a) Disconnect the O3 ECU connector.

(b) Measure the resistance and voltage according to the value(s) in the table below.





* If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the O3 ECU connector.

(d) Measure the voltage according to the value(s) in the table below.





* If the result is not as specified, the ECU may have a malfunction.