Reassembly

1UR-FSE ENGINE MECHANICAL: CYLINDER HEAD: REASSEMBLY

1. INSTALL STUD BOLT

NOTICE:
If a stud bolt are deformed or threads are damaged, replace it.

(a) Using E6 and E8 "TORX" socket wrenches, install the stud bolts.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf) for stud bolts A, B, C and D





2. INSTALL NO. 2 STRAIGHT SCREW PLUG

(a) Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 straight screw plugs.





Torque : 85 Nm (867 kgf-cm, 63 ft-lbf)

3. INSTALL NO. 1 STRAIGHT SCREW PLUG

(a) Using a 10 mm hexagon wrench, install 6 new gaskets and the 6 straight screw plugs.





Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

4. INSTALL VALVE SPRING SEAT

(a) Install the valve spring seats to the cylinder head.

5. INSTALL VALVE STEM OIL SEAL

(a) Apply a light coat of engine oil to new oil seals.





NOTICE:
Pay attention when installing the intake and exhaust oil seals. For example, installing the intake oil seal into the exhaust side or installing the exhaust oil seal to the intake side can cause installation problems later.

HINT
The intake valve oil seals are gray and the exhaust valve oil seals are black.

(b) Using SST, push in the oil seals.





SST : 09201-41020

NOTICE:
Failure to use SST will cause the seal to be damaged or improperly seated.

6. INSTALL INTAKE VALVE

(a) Apply plenty of engine oil to the tip area of the intake valve shown in the illustration.





(b) Install the valve, compression spring and spring retainer to the cylinder head.

NOTICE:
Install the same parts in the same combination to original locations.

(c) Using SST and wooden blocks, compress the spring and install the retainer lock.





SST : 09202-70020

09202-00010

09202-01010

09202-01020

(d) Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.





NOTICE:
Be careful not to damage the retainer.

7. INSTALL EXHAUST VALVE

(a) Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.





(b) Install the valve, compression spring and spring retainer to the cylinder head.

NOTICE:
Install the same parts in the same combination to their original locations.

(c) Using SST and wooden blocks, compress the spring and install the retainer lock.





SST : 09202-70020

09202-00010

09202-01010

09202-01020

(d) Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.





NOTICE:
Be careful not to damage the retainer.