Scan Tool Testing and Procedures

METER: METER / GAUGE SYSTEM: DATA LIST / ACTIVE TEST

1. DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical, Powertrain or Chassis / (desired system) / Data List.

(e) According to the display on the Techstream, read the "Data List".

Combination Meter:









Engine:





Electric Parking Brake:





2. ACTIVE TEST

HINT
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Active Test.

(e) According to the display on the Techstream, perform the "Active Test".

Combination Meter:









HINT
Perform the test with the vehicle stopped and engine idling.

*1:

* It is normal that door will be locked automatically when performing the speedometer Active Test.
* The displayed value has the same units (km/h, mph) as the main scale of the vehicle's speedometer.
* The needle position should be within the acceptable tolerance.
*2: If this Active Test is being performed and the engine switch is turned off and then on (IG), the A/T and ODO/TRIP display area's background may turn white. If this occurs, end this Active Test and turn the engine switch off.

*3: w/ Pre-collision system

*4: w/ Cruise control system, w/ Dynamic radar cruise control system

*5: w/Automatic high beam system

Main Body: