Programming and Relearning

LIGHTING: LIGHTING SYSTEM: CUSTOMIZE PARAMETERS

1. CUSTOMIZING FUNCTION WITH THE TECHSTREAM (REFERENCE)

NOTICE:
* When the customer requests a change in a function, first make sure that the function can be customized.
* Be sure to make a note of the current settings before customizing.
* When troubleshooting a function, first male sure that the function is set to the default setting.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus:

(1) Select: Customize Setting /

(e) Select the setting by referring to the table below.

Illuminated Entry:





Light Control:





HINT
The sensitivity adjustment may be difficult to confirm. Check by driving the customer's vehicle.

*1





HINT
When the setting is closer to the "Light" side, the system dims the indicator lights even when the surrounding area is relatively bright. When the setting is closer to the "Dark" side, the system waits until the surrounding area is darker before dimming the indicator lights.

*2





HINT
When the setting is closer to the "Dark" side, the system cancels the dimming of the indicator lights even when the surrounding area is relatively dark. When the setting is closer to the "Light" side, the system waits until the surrounding area is brighter before canceling the dimming of the indicator lights.

*3





HINT
When the setting is closer to the "Light" side, the system turns the lights on even when the surrounding area is relatively bright. When the setting is closer to the "Dark" side, the system waits until the surrounding area is darker before turning on the lights.

2. Door linked map light and personal light illumination control

Mode 1: When door is opened, map light of opened door illuminates, or personal light illuminates

Mode 2: When door is opened, all map lights and personal lights illuminate

Mode 3: Map lights and personal lights are not linked to doors

(a) To change modes, press the map light assembly DOOR and ON switch simultaneously, and then turn the engine switch from off to on (IG). Each engine switch off to on (IG) operation will change the mode (Mode 1->Mode 2->Mode 3->Mode 1).

HINT
After changing modes, the map light responds by blinking as follows: Mode 1: once; Mode 2: twice; Mode 3: three times.