Scan Tool Testing and Procedures
LIGHTING: LIGHTING SYSTEM: DATA LIST / ACTIVE TEST
1. DATA LIST
HINT
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the menus.
(f) Enter the following menus:
(1) Select: Body Electrical / (desired system) / Data List /
(g) According to the display on the Techstream, read the "DATA LIST".
Main Body
Combination Switch
Body No. 5
Body No. 4
Back Door
AFS
2. ACTIVE TEST
NOTICE:
When a Rear Junction Block ECU and Multiplex Network Front Light ECU (Front Controller) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.
HINT
Using the Techstream to perform Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Test.
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus:
(1) Select: Body Electrical / (desired system) / Active Test /
(f) According to the display on the Techstream, perform the "ACTIVE TEST".
Main Body
Driver Door
Passenger Door
Rear Left Door
Rear Right Door
Body No. 4
Body No. 5
AFS
