Front Axle Hub

AXLE: FRONT AXLE HUB (for 2WD): ON-VEHICLE INSPECTION

1. REMOVE FRONT WHEEL

2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Removal

3. REMOVE FRONT DISC Removal

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, measure the looseness near the center of the axle hub.





Maximum:

0.05 mm (0.0020 in.)

NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface.

If the looseness exceeds the maximum, replace the axle hub.

5. INSPECT FRONT AXLE HUB RUNOUT

(a) Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.





Maximum:

0.05 mm (0.0020 in.)

NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface.

If the runout exceeds the maximum, replace the axle hub.

6. INSTALL FRONT DISC Installation

7. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Installation

8. INSTALL FRONT WHEEL

Torque : 140 Nm (1428 kgf-cm, 103 ft-lbf)