Installation

1UR-FSE FUEL: FUEL PRESSURE SENSOR: INSTALLATION

1. INSTALL FUEL PRESSURE SENSOR

(a) Install a new gasket to the fuel pressure sensor.

(b) Using SST, install the fuel pressure sensor to the fuel delivery pipe.





SST : 09922-10010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)

NOTICE:
* Do not apply oil to threads of the pressure sensor and delivery pipe.
* Do not allow foreign matter to enter the pipe during the installation.

HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.8 in.).
* Make sure SST and torque wrench are connected in a straight line.

(c) Connect the connector.





2. INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY





3. INSTALL INTAKE MANIFOLD

(a) Install the intake manifold Installation.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.

6. ADD ENGINE COOLANT Service and Repair

7. INSPECT FOR COOLANT LEAK Component Tests and General Diagnostics

8. INSPECT FOR FUEL LEAK Fuel System